OLCM1U
Installation Instructions
10
Adjustments
CAUTION:
Watch for pinch points! Do not place fingers
between movable parts.
Yaw
The ceiling mounts allows yaw adjustment in 45° increments in
each direction.
1.
Remove two bolts and washers connecting column collar to
mount assembly box. (See Figure 14)
2.
Adjust yaw in 45° increment until desired position is
achieved. (See Figure 14)
3.
Reinstall bolts and washers removed in Step 1. (See Figure
14)
Figure 14
Tilt
CAUTION:
Watch for pinch points! Do not place fingers
between movable parts.
The interface brackets allow -7.6° to 20° tilt, and can be locked
at -7.6°, -5°, 0°, 5°, 10°, 15° and 20° tilt. (See Figure 15)
Figure 15
4.
If necessary, loosen button head tilt friction bolt (located on
side of interface bracket). (See Figure 16)
5.
Adjust tilt as required. (See Figure 16)
6.
The tilt may be locked at -7.6°, -5°, 0°, 5°, 10°, 15° and 20°
using one 1/4-20 x 2" Phillips head screw (N), one 1/4-20
lock nut (Q) and two 1/4" washers (T) per interface bracket.
(See Figure 15) and (See Figure 16)
NOTE:
Use of washers (T) is optional.
7.
Tighten button head tilt friction bolt as necessary.
Figure 16
1
column collar
3
2
+/- 45°
1.91
48.4
0° HOLE
LOCKOUT
+5°AND -15°
HOLE LOCKOUT
-5° AND -20°
HOLE LOCKOUT
+7.6° HOLE
LOCKOUT
- 10°
2.48
63.0
-10° HOLE
LOCKOUT
Tilt
friction
bolt
4
4
7
(Displays not shown)
6
(N)
(Q)
0° tilt
20° tilt
5
(T) x 2
