LEGRAND CHIEF PT Series, Installation Instructions Manual

Installation Instructions

 TIL1X2PT / TIL1X3PT / TIL1X4PT / TILVABPT

5

INSTALLATION

Preinstallation

IMPORTANT ! : 

Reference the LED screen installation 

manual for specific instructions regarding care, handling, 
cabling and installation of the LED screens. 

CAUTION:  

Handle the LED screens with care, being 

careful to not impact or drop the LED screen.

CAUTION:  

There is a magnetic surface on the front of the 

LED screen. To prevent damage ensure that no metallic 
object is pulled onto the LED screen.

NOTE:  

When planning the installation, remember the 

requirement to run power and signal to the video wall.

Preparing LED Screens

1.

Attach four mounting buttons (L) per LED screen, one to 

each corner of LED screen, with four M5 x 20mm Phillips flat 

head screws (K). (See Figure 1)

Figure 1

Determining Installation Site

IMPORTANT ! : 

The top of the LED screen is 7" above 

the center line of the mounting lags in the mounting slots. 
(See Figure 2)

NOTE:  

If desired, the mount installation may be started in the 

middle of the video wall, attaching mounts out from the 
center to the left and right ends. Installation on smaller 
walls may be easier if started at the left side of the video 
wall using the following instructions.

IMPORTANT ! : 

1.

Determine location for the 

top left

 corner of the LED wall. 

(See Figure 2)

2.

Make a mark 7" below the planned top left corner of the LED 

wall. (See Figure 2)

3.

Using a level, mark a horizontal line across width of LED 

wall from the mark made in Step 2. 

NOTE:  

This line will indicate the center line for the location of the 

mounting lags in the mounting slots for the top mount(s) 
in the video wall. The oversize mounting slots will allow 
some upward adjustment as needed. (See Figure 2) and 
(See Figure 3)

Figure 2

Figure 3

(OPTIONAL) Adding Vertical Connector Kit 

NOTE:  

If more LED screens will need to be added to the top or 

bottom of the screen configuration, add TILVABPT 
vertical connector kit to top or bottom of wall mount 
using the following instructions. If you are NOT adding 
the TILVABPT connector kit, proceed to 

Installing 

First Mount 

section.

(L)

LED screen

1

(K)

[TIL1X2 shown as example - 

2 screens shown]

Location for top left corner of LED wall

1

2

7"

3

7”

7”

[TIL1X2PT shown as example] 

3

Mounting slot

center line