LEGRAND CHIEF PT Series, Installation Instructions Manual

 TIL1X2PT / TIL1X3PT / TIL1X4PT / TILVABPT

Installation Instructions

8

10. Using a level on the front of the mount in various places, use 

a 1" socket and T-handle driver to adjust the leveling feet on 

the mount until the mount is plumb. (See Figure 11)

CAUTION:  

Over-torquing may cause damage. Do NOT 

use a drill to make the depth adjustment.

Figure 11

Adding Additional Mounts

1.

Hold additional wall mount against wall ensuring that 

mounting slot is lined up with center line marked on the wall 

in 

Determining Installation Site

 section. Double-check 

with a level. (See Figure 6)

2.

Mark mounting holes in two top mounting slots along the 

horizontal line. (See Figure 6)

3.

The mounting holes are 17.22" apart on-center.  (See 

Figure 6)

4.

Drill two pilot holes (same size as those drilled for first 

mount) at each marked location and use same fasteners 

used on the first mount. 

5.

Partially install two fasteners into wall, but do NOT 

completely tighten to wall. 

6.

Hang wall mount, aligning upper mounting slots over 

fasteners, and adjust side-to-side for proper location. 

7.

install two 1/4-20 x 4-1/2" hex head bolts (H) and two 1/4" 

steel washers (F) into the right or left side of the second 

mount at 

both top and bottom

, and through into the left or 

right side of the first mount. (See Figure 12)

NOTE:  

The second mount may be attached to either the left or 

right side of the first already installed mount.

8.

Loosely fasten second mount to first mount using two 1/4" 

steel washers (F) and two 1/4-20" flanged hex nuts (E). (See 

Figure 12)

9.

Slide adjustment washers (A) behind head of upper fasteners 

in mount. (See Figure 9)

10. Tighten both fasteners between mounts (at top and bottom 

where the second mount is connected to the first mount). 

(See Figure 12)

11. Lay levels across flat of the mounting holes and center-of-

screen indicators, and vertically along side of mount to 

ensure wall mount is square and level.

NOTE:  

Lift up slightly on the far side of the second mount to help 

level the mount.

12. Hold the adjustment washers in place by hand and tighten 

the fasteners at the top of the mount.

13. Drill lower pilot holes at attachment locations and use same 

fasteners used at top of mount. 

14. Install two fasteners through lower part of mount and tighten. 

Figure 12

Leveling feet

locations

10

7

Mount already

attached to wall

Additional mount

being added to
first mount

(H) x 2

(F) x 4

(E) x 2

FIRST MOUNT

SECOND MOUNT

8

2

[TIL1X3PT shown as example] 

10