Installation Instructions
TIL1X2PT / TIL1X3PT / TIL1X4PT / TILVABPT
9
IMPORTANT ! :
For larger LED walls it is helpful to check
placement and alignment of the mounts by putting a few
LED housings in place in the bottom row of the installed
mounts (referencing the LED screen installation manual
for specific instructions) during the mount installation,
checking alignment before removing the housings, and
then continuing the installation.
IMPORTANT ! :
Continually recheck the alignment and
overall flatness of the wall mounts during the installation
process.
15. Continue the installation process until all wall mounts are
attached.
16. Install one #10 x 1/2" Phillips tapping screw (G) into left
upper LED mounting button hole for each LED screen
space. Install the tapping screws ONLY
on the furthest left
column of mounts
. (See Figure 13)
Figure 13
IMPORTANT ! :
The tapping screws keep the LED
screens centered on the mount, and are ONLY installed
on the furthest left column of mounts.
17. Using a drill driver makes installation of the tapping screws
(C) easier.
Model
Fastener
Qty
TIL1X4PT
4
TIL1X3PT
3
TIL1X2PT
2
[TIL1X2PT shown as example]
16
(G)
Summary of Contents for CHIEF PT Series
Page 16: ...Installation Instructions TIL1X2PT TIL1X3PT TIL1X4PT TILVABPT 16 ...
Page 25: ...Installation Instructions TIL1X2PT TIL1X3PT TIL1X4PT TILVABPT 25 ...
Page 26: ...TIL1X2PT TIL1X3PT TIL1X4PT TILVABPT Installation Instructions 26 ...
Page 27: ...Installation Instructions TIL1X2PT TIL1X3PT TIL1X4PT TILVABPT 27 ...
