Installation Instructions
RMF3/RMT3/RLF3/RLT3
13
Installing to a Concrete Wall
1.
Determine the center of the TV screen, and where it should
be located on the wall.
2.
Line up the horizontal slots on mount (W/X) with center of
screen marking to determine vertical center. (See Figure 8)
3.
Measure up 4.2" (106mm) from the center point to mark
location of the upper mounting slots.
4.
Measure down 4.2" (106mm) from the center point to mark
location of the lower mounting slots.
5.
Using a level, mark the wall through both upper mounting
slots. (See Figure 8)
Figure 8
CAUTION:
MINIMUM HORIZONTAL DISTANCE
BETWEEN WALL BRACKETS IS 16" (406.4mm). Do not
place mounting brackets closer together than 16" (406.4mm).
6.
Remove mount (W/X) from wall and drill one 3/8" x 3-1/2"
(9.5mm x 88.9mm) pilot hole at each marking (four total).
7.
Install an anchor (P) into each pilot hole using a hammer,
making sure that the anchor is flush with the wall.
8.
Replace mount (W/X) on wall and partially install two 5/16 x
2-1/2" flanged lag bolts (N) into upper anchors but do not
tighten to wall.
9.
Partially install two 5/16 x 2-1/2" flanged lag bolts (N) into
lower anchors but do not tighten to wall.
10. Place one slotted washer (Q) over each flanged lag bolt.
(See Figure 8)
11. Tighten lag bolts to secure mount (W/X) to wall at upper
mounting slots.
12. Slide mount (U) to approximate center of screen location.
Attaching Interface Brackets to Screen
1.
Align the center of the bracket (S and T or U and V) with
center of screen. (See Figure 9)
NOTE:
The diamond-shape holes in the bracket correspond to
the center of the mount.
Figure 9
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SERIOUS PERSONAL
INJURY OR DAMAGE TO EQUIPMENT!
WARNING:
Using screws of improper size may damage
your display. Properly sized screws will easily and completely
thread into display mounting holes. If spacers are required,
be sure to use longer screws of the same diameter.
5
6
x 4
(P) x 4
7
8
11
(N) x 2
(Q) x 2
9
(Q) x 2
13
11
(N) x 2
(W) x 1
(X) x 1
9
Center of bracket
Pull cord
[Brackets S and T shown]
(MA)
(A-L)
(MB)
(RMF3/RLF3 shown)
NOTE: Use universal washer (MB) ONLY with M4, M5,
and M6 screws.
