TILD1X05US / TILD1X1US / TILD1X2US / TILVAB2
Installation Instructions
2
DISCLAIMER
Legrand
|
AV and its affiliated corporations and subsidiaries
(collectively “Legrand
|
AV”), intend to make this manual
accurate and complete. However, Legrand
|
AV makes no claim
that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Legrand
|
AV
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Legrand
|
AV
assumes no responsibility for accuracy, completeness or
sufficiency of the information contained in this document.
Chief® is a registered trademark of Legrand AV Inc.
DEFINITIONS
MOUNTING SYSTEM:
A MOUNTING SYSTEM is the
primary Chief product to which an accessory and/or component
is attached.
ACCESSORY:
AN ACCESSORY is the secondary Chief
product which is attached to a primary Chief product, and may
have a component attached or setting on it.
COMPONENT:
A COMPONENT is an audiovisual item
designed to be attached or resting on an accessory or mounting
system such as a video camera, CPU, screen, display,
projector, etc.
WARNING:
A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION:
A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all mounting systems
are properly assembled and installed using the instructions
provided.
WARNING:
Failure to provide adequate structural strength
for this mounting system can result in serious personal injury
or damage to equipment! It is the installer’s responsibility to
make sure the structure to which this mounting system is
attached can support five times the combined weight of all
equipment. Reinforce the structure as required before
installing the mounting system. The wall to which the
mounting system is being attached may have a maximum
drywall thickness of 5/8” (1.6cm). Do not install drywall
anchors into the seam between drywall pieces.
WARNING:
The TILD1X05US / TILD1X1US / TILD1X2US
LED wall mounts are designed for use with LED panels only.
Exceeding the weight capacity (listed) can result in serious
personal injury or damage to equipment! Do NOT attach LED
panels to TILD1X05US / TILD1X1US / TILD1X2US LED
video wall mounts that exceed 30 lbs (13.6 kg) regardless of
the size or design of the configuration. See figure below for
examples.
WARNING:
Use this mounting system only for its intended
use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
WARNING:
Never operate this mounting system if it is
damaged. Return the mounting system to a service center for
examination and repair.
WARNING:
Do not use this mounting system outdoors.
IMPORTANT ! :
The TILD1X05US / TILD1X2US /
TILD1X2US LED wall mounts are designed to be mounted to a
bare 8" concrete or 8"x8"x16" concrete block wall.
--SAVE THESE INSTRUCTIONS--
ONE LED PANEL
30 lbs (13.6 kg)
maximum
ONE LED PANEL
30 lbs (13.6 kg)
maximum
TILD1X05US (example)
TILD1X1US (example)
