10
UP
STOP
DOWN
BUS
C
O
M
5V
RJ-22 Jack
(Connection to
Wall Switch)
RJ-22
Jack (QEYE)
Optional Built-In Video Projector Interface
5/12 Volt
Screen Trigger
on Projector
Black
Red
VPI Trigger
Module
CAUTION:
The projector must be turned off before
connecting the trigger wires to the projector. Failure to
do so may damage the controller.
ATTENTION: Le projecteur doit être éteint avant de
brancher les fils de déclenchement à celui-ci. Tout
manquement à cette instruction pourrait endommager le
contrôleur.
Use 2-conductor 18–24 gauge wire to extend the low voltage
connection from the projector’s 5 or 12-volt screen trigger output
to the length required to reach the VPI.
NOTE:
When extending the low voltage connection from the
projector’s screen trigger output polarity does not matter.
The
red and black wires from the VPI are interchangeable.
IMPORTANT NOTE:
The wall switch is REQUIRED to make any
limit switch adjustments, EVEN if a third party control system is
used. Therefore, it is advised to wire the switch or provide a
3-conductor connection that is accessible.
3-conductor 20–24 gauge wire can be used in place of the
supplied RJ-14 cable to connect the wall switch. Connect the BUS
terminals on the wall switch to the corresponding BUS terminals
on the splitter board.
See 120V or 220V wiring diagram for complete wiring
instructions.
