10
installation & setup
step two
|
remove the existing device
Check for the following wires:
1
HOT or LINE: Receives power from the circuit box Referred to as “hot” for the
purposes of this guide Do not touch or let “hot” wires contact other wires
2
LOAD: Directs power to your light(s)
3
NEUTRAL: Creates a path to return current to the power source when the
device is off Required for your switch installation
4
GROUND: Provides a safe path for electricity in the event of a short circuit
NOTE: Refer to the “faqs” on page 25 if you are unsure of your wiring.
Summary of Contents for HKRP10
