29
• Confirm the device is shown on screen, then scan the setup code located on the
device, instruction manual, or inner packaging If the app displays “Couldn’t add
accessory” after scanning the code:
a Exit the app Make sure it is not running in the background
b Restart the app
c Restore the accessory to factory settings
d Add the accessory again
Summary of Contents for HKRP10
