background image

www.kenall.com  |  P: 800-4-Kenall  |  F: 262-891-9701  |  10200 55th Street Kenosha, Wisconsin 53144, USA         

This product complies with the Buy American Act: manufactured in the United State swith more than 50% of the component cost of US origin It may be covered by patents 
found at www.kenall.com/patents. Content of specification sheets is subject to change; please consult www.kenall.com for current product details. ©2019 Kenall Mfg.Co. 

1

INSTALLATION INSTRUCTIONS

F-4260_091118

Luminaire for Parking Garages

TEKDEK

 LED

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should 

always be followed, including the following:

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE 

INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND 

OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED. 

CE PRODUIT DOIT ÊTRE INSTALLÉ EN CONFORMITÉ AVEC LE CODE DE 

L'INSTALLATION PAR UNE PERSONNE QUI connaît BIEN LA CONSTRUCTION ET 

LE FONCTIONNEMENT DU PRODUIT ET LES RISQUES ENCOURUS.

DISCONNECT POWER TO ALL CIRCUITS BEFORE WIRING FIXTURE. INSTALL IN 

ACCORDANCE WITH ALL NATIONAL, STATE, AND LOCAL CODES. DO NOT 

CONNECT TO AN UNGROUNDED SUPPLY. READ ALL FIXTURE MARKINGS AND 

LABELS TO ENSURE CORRECT INSTALLATION OF FIXTURE. SUPPLEMENTAL 

INSTRUCTIONS MAY BE LOCATED ON THE FIXTURE, IN ADDITION TO THIS 

INSTRUCTION SHEET, REGARDING ORIENTATION, OR MOUNTING RESTRICTIONS.

SAVE THESE INSTRUCTIONS

SAFETY RECOMMENDATION

TD17 SERIES

SAFETY RECOMMENDATION

A 1/16" diameter aircraft cable with end-loop (not included) is recommended for 

attaching the fixture structural to the upper structural.

1/16" DIA. AIRCRAFT CABLE

(SUPPLIED BY OTHERS)

AIRCRAFT CABLE ATTACH

TO UPPER STRUCTURAL

SCREW (SUPPLIED BY OTHERS)

A 1/16" diameter cable with end-loop (not included) is recommended 

for attaching the fi xture structural to the upper structural

Summary of Contents for Kenall TEKDEK LED TD17 Series










Reviews: