LEGRAND KEOR T EVO 10-60 KVA Installation & Operation Manual Download

Page: 17 / 94

KEOR T EVO

Installa

tion & Oper

ation M

anual

Description of the Symbols Used in the Manual

This symbol points out the instructions which are especially important.

This symbol points out the risk of electric shock if the following instruction is

not followed.

This symbol points out the instructions, which may result with injury of the

operator or damage of the equipment if not followed.

All packing material must be recycled in compliance with the laws in force in the

country where the system is installed.

Description of the Symbols Used in the Manual

UPS: Uninterruptible Power Supply
ESD: Emergency Switching Device
RS232: Serial Communication Protocol
RS485: Serial Communication Protocol
MODBUS: Modicon Communication Protocol
SNMP: Simple Network Management Protocol
V: Volt
A: Ampere
P: Power

For Mains Supply, Auxiliary Mains Supply, Output, Battery Circuit Breaker and Maintenance Bypass Circuit

Breaker;
“ON”: Closing the Circuit
“OFF”: Opening the Circuit

KEOR T EVO

Installa

tion & Oper

ation M

anual

Description of the Symbols Used in the Manual

This symbol points out the instructions which are especially important.

This symbol points out the risk of electric shock if the following instruction is

not followed.

This symbol points out the instructions, which may result with injury of the

operator or damage of the equipment if not followed.

All packing material must be recycled in compliance with the laws in force in the

country where the system is installed.

Description of the Symbols Used in the Manual

For Mains Supply, Auxiliary Mains Supply, Output, Battery Circuit Breaker and Maintenance Bypass Circuit

Breaker;
“ON”: Closing the Circuit
“OFF”: Opening the Circuit

KEOR T EVO

Installa

tion & Oper

ation M

anual

5. Requirement

5.2.

Placement

This product meets the safety requirements for devices to be operated in restricted access locations according to EN
60950-1 safety standard, which states that the owner should guarantee the following:
• Access to the equipment can only be gained by service persons or by users who have been instructed about the

reasons for the restrictions applied to the location and about any precautions that shall be taken and,
• Access is through the use of a tool or lock and key, or other means of security and is controlled by the authority

responsible for the location.
• UPS is not designed for outdoor application.
• The equipment and the batteries should not be exposed to direct sunlight or placed near to a heat source.
• Recommended operating temperature and humidity values are listed on the Appendix-4 T

echnical Specifica

tions.

• Avoid dusty environments or areas where dust of conductive or corrosive materials is present.
• The connection and the circuit breakers are at the front of UPS. Leave access at the front of the UPS for maintenance.

(Refer to Figure.4.2-4)
• Air outlets of the UPS are at the front, back and on both sides. Leave access at the front side, back side and from both

lateral sides for ventilation and battery replacement. (Refer to Figure.4.2-1, 4.2-2, 4.2-3 and 4.2-4)
• Recommended environmental humidity condition is between 20-95% (non-condensing).

The UPS must be placed and stand in a vertical position throughout the transportation.

Use suitable equipment to remove the UPS from the pallet.

The equipment shall be packed properly during transportation. Therefore it is

recommended to keep the original package for future need.

All packing material must be recycled in compliance with the laws in force in the

country where the system is installed.

5.1.

Transportation

Environment Requirement

Model (kVA)

Max. dissipation at no load

(W)