Wattstopper
®
DLM Wireless Scene Switch with IPv6/Bluetooth
®
Low Energy Technology
Quick Start Guide • Guide de démarrage rapide • Guía de inicio rápido
No: 27360 – 10/21 rev. 8
Catalog Number • Numéro de Catalogue • Número de Catálogo: LMSW-605
Country of Origin: Made in China • Pays d’origine: Fabriqué en Chine • País de origen: Hecho en China
SPECIFICATIONS
Power Supply .......................... Battery powered, CR123A Lithium Ion, 3 VDC
Connection to DLM Network ............Wireless via LMRC-611 room controllers
......................................................................................or LMBC-650
Wireless Radio ........................................Single, Concurrent 802.15.4 and
....................................................Bluetooth Low Energy, 2.4GHz
Wireless Communication
IPv6 Mesh (6LoWPAN) Range ...........................................up to 60 ft.
Bluetooth low energy Range ..............................................up to 30 ft.
60 ft. max. between LMSW-605 and room controller or bridge
Wireless Encryption ..........................................AES-128 bit symmetric key
Environment ............................................................... For Indoor Use Only
Operating Temperature ...............................32° to 104°F (0° to 40°C)
Storage Temperature .................................23° to 140°F (-5° to 60°C)
Relative Humidity .....................................5 to 95% (non condensing)
Compliance/Regulatory
FCC, RoHS,
Bluetooth certified
UL and cUL listed (E101196)
Patent Pending
Once paired to an LMRC-611 wireless
room controller or LMBC-650 wireless
bridge, this unit is set for Plug n’ Go™
operation, adjustment via the DLM
Configuration App is recommended
to meet the local energy code where
installed.
The DLM Wireless 5-Button scene switch is a
wireless battery powered wall switch intended for
operation with wireless room controllers.
Do not apply cleaning solvent directly onto unit.
Apply cleaning solvent onto a cloth, then wipe the
unit to clean it.
INSTALLING THE SWITCH
Connect ground wire if installing
next to Class 1 power. If not, there
is no need to connect the ground
wire (please comply with local code).
Pull to remove
battery protection tab
before use
NOTE:
Installation shall be in accordance with all applicable
regulations, local, and NEC codes
BUTTONS AND INDICATORS
Status/Battery
Life LED
Scene Button (4)
Configuration Button
(behind switch plate)
Tap when load OFF:
Turn ON to last level
Tap when load ON:
Go to full bright
Press & Hold:
Ramp Up
Tap when load ON:
Turn OFF
Press & Hold:
Ramp Down
LED Color
Function
White
Unit Boot Up
Green, 1 Blink
Config Button Pressed
Blinking Green
Push to Pair Mode
Red, 1 Blink
In normal operation, if any button is
pressed, indicates low battery
Also blinks if Reset button is pressed
Blinking Red
Push n’ Learn Mode
Blue
Any button or paddle pressed during
normal operation
INSTALLING THE BUTTONS
The LMSW-605-W (White) ships with the buttons installed. All
other switch colors ship with our quick install button kit. To install:
Frame
Buttons
Switch Body
Place buttons into Body, then snap-on frame,
pressing down till tabs click.
Summary of Contents for LMSW-605-W
Page 5: ...5...
