X
X
X
3
Preparing for Access
IP Addressing
If the XAP-1610 is connected to a network with a 192.168.0.X address scheme,
and your computer shares a similar address on the same network, you can skip
to the next step,
Access and Setup
.
If your network uses an address scheme other than 192.168.0.X, you’ll need
to set a temporary static IP address on the computer you’re using for config-
uration. To do so, set the IP address of your computer to an address in the
192.168.0.X range, then set the Gateway/Router address to 192.168.0.10 (the
default IP address of the XAP-1610).
Once you’re finished configuring the AP, you can return your computer’s IP
configuration to normal, typically “Obtain Automatically/DHCP.”
n
Note:
Visit
http://luxul.com/ip-addressing
to learn more about
changing your computer’s IP address and getting connected.
4
Access and Setup
Getting Connected
X
Connecting Via an Ethernet Device:
Use Ethernet cable to connect your
computer to the PoE+ switch or PoE injector to which the XAP-1610 is
connected. Ethernet is the preferred method of connection.
X
Connecting Via a Wireless Device:
Connect your client device to the
XAP-1610 default wireless network named
Luxul_XAP1610
or
Luxul_
XAP1610_5G
. The wireless network will run in Open Security mode, so no
passphrase is required until Wireless Security is configured.
