Page 10
Attaching the Display Stand to a Wall With Steel Studs or Cinderblocks
NOTE
: Adjust torque on power driver to the “drill” setting.
1. Use power driver and ½” drill bit to drill holes in all the marked keyhole
slot locations. You must hit wall studs (where applicable) in top and bottom
keyhole slots on at least one side of the display stand for proper support.
NOTE
: If securing to cinderblocks, avoid drilling into webs and sides
as shown. (
FIGURE C
)
2. Insert SNAPTOGGLE
®
anchor (B) into a hole by holding the
metal channel flat alongside the plastic straps and sliding the
channel through the hole as shown. (
FIGURE D
)
3. Make the plastic strap handles even to force the metal channel
perpendicular to the entire anchor. (
FIGURE E
)
4. Secure the anchor by firmly sliding the plastic cap along the
straps until the flange of the cap is flush with the wall.
Plastic Cap
Plastic
Straps
Metal
Channel
B
FIGURE D
6. Repeat steps 2 - 5 to insert SNAPTOGGLE
anchors (B) into all of your keyhole slot location
holes drilled during step 1.
NOTE
: Adjust torque on power driver to lightest
setting and only increase as necessary.
7. Team lift the display stand and place it against your
mounting wall aligning keyhole slots with the
prepared holes and anchors.
Plastic Cap
Handles
Metal
Channel
Making handles even forces metal
channel perpendicular to entire anchor.
Slide plastic cap along straps.
FIGURE E
8. Place a level on the top center of your display stand and
make any final adjustments to the leveling feet (by carefully
team tilting the display stand) as necessary.
9. Use power driver, 7/16” socket, (4x) ¼”-20 x 2½” bolts
(C) and (4x) ¼” washers (D) through keyhole slots and into
the anchors to secure the stand to your wall.
FIGURE F
Bend straps
toward wall
to remove
from anchor.
Sides
Web
FIGURE C
ATTACHING THE DISPLAY STAND TO YOUR WALL (IF PURCHASED, CONTINUED)
5. The remaining sections of this topic show you how to attach the display stand to your specific wall type
as follows:
• “Attaching the Display Stand to a Wall With Steel Studs or Cinderblocks” on page 10.
• “Attaching the Display Stand to a Wall With Wood Studs” on page 11.
• “Attaching the Display Stand to a Solid Concrete Wall” on page 11.
NOTE
: If your installation requires additional measurements and details, refer to the technical specification
(120-00027) at www.legrandav.com.
5. Snap off plastic straps from the anchor by carefully bending them toward the wall. (
FIGURE F
)
