Page 8
INTRODUCTION
NOTE
:
• Please take the time to carefully unpack and inspect all of the products you ordered and save this
instruction sheet for future use.
• Maintenance and care information is provided in Care and Cleaning of Products (I-00788) and
Unpacking and Handling Precautions (I-00787) for your convenience.
• All documents may be accessed at www.legrandav.com.
Your Forum™ collaboration suite configuration may include a free-standing display stand, a floor-to-wall
display stand, additional Lever Lock™ kit, and/or a table equipped with optional Wiremold ModPower™
modular power units.
Use the topics in this instruction sheet in order of appearance and only include applicable sections based
on any additional Forum items you may have purchased. Topics cover attaching the floor-to-wall display
stand to your wall, the configuration of additional Lever Lock plates brackets and panels, table assembly,
and cable management with or without ModPower units.
You’ll also find content and additional reference covering the included Chief Fusion Fixed Display
Mount and any optional Wiremold On Surface Primary (MDSA10-WH), Middle (MDCA3-WH), and End
(MDEA3-WH) ModPower™ Units you may have purchased for your optional table(s).
For more information, refer to the following Forum product page at www.legradav.com:
https://www.legrandav.com/Products/Technical_Furniture/Collaboration/Forum_Collaboration_Suite
1. Use socket wrench and 5/16” socket to remove (4x) 10-32 nuts (accessed
through the front opening and located inside the display stand columns)
from studs on the front filler panel and carefully set aside panel and nuts
for re-installation. (
FIGURE A
)
2. Carefully tug at the magnetic sides of the front panel to remove it from the
display stand frame and set aside front panel for re-installation.
NOTE
:
• Any indentations made to the acoustic felt (PET) material of the front or
filler panel may be removed by applying steam.
• Remove dust and debris from panels with a clean, soft, lint-free cloth or
vacuum.
• Bleach and cleaning agents are not recommended, as they may discolor
the material.
REMOVING THE FRONT PANEL FROM YOUR DISPLAY STAND
FIGURE A
Front Filler
Panel
Front
Panel
A
