ATTACHING THE DISPLAY STAND TO YOUR WALL (FLOOR-TO-WALL MODELS ONLY)
Page 9
NOTE
:
• If securing to a wall with steel or wood studs, use a
pencil and a stud finder to align your keyhole slot drilling
locations along top and bottom keyhole slot lines
(drawn during step 2) to hit the studs.
• If you are not securing your display stand into steel studs
using the provided SNAPTOGGLE
®
anchors (C), and
instead are going into wood studs, you must provide your
own lag bolt hardware that meets the appropriate weight
ratings specified in “Weight Ratings” on page 5.
• If you are not securing your display stand into
cinderblocks using the provided SNAPTOGGLE
anchors (B), and instead are going into a solid concrete
wall, you must also provide your own concrete anchor
hardware meeting the appropriate weight ratings
specified.
1. Carefully team lift your display stand (A) and place it on its feet against your desired mounting wall.
NOTE
: Consider power receptacles on the wall and power requirements when positioning your display
stand.
2. Use a pencil to draw horizontal lines on your wall from
the center of the top and bottom keyhole slots (shaded)
of the display stand. (
FIGURE B
)
3. With the display stand still on the wall, mark your desired
keyhole slot drilling locations along top and bottom
keyhole slot lines (drawn during previous step) as shown.
4. Carefully team lift your display stand away from the wall.
WARNING:
This procedure requires at least one additional person.
AVERTISSEMENT:
Cette procédure nécessite au moins une personne supplémentaire.
WARNING:
The display stand must always bear its weight on its feet when wall mounted.
AVERTISSEMENT:
Le présentoir doit toujours supporter son poids sur ses pieds lorsqu'il est
fixé au mur.
FIGURE B
NOTE
: Draw lines as close to the middle
of the keyhole slot as possible.
WARNING:
Customer-provided mounting hardware must be used on all four keyhole slot locations when
securing the display stand to any wall type and the unit must be set on the ground.
AVERTISSEMENT:
Le matériel de montage fourni par le client doit être utilisé sur les quatre emplace-
ments des trous de serrure lors de la fixation du support d'affichage à tout type de mur et l'unité doit être
placée sur le sol.
WARNING:
When securing to a wall with steel or wood studs, your mounting hardware must hit the stud
through both top and bottom keyhole slot locations on at least one side of your display stand for proper
support.
AVERTISSEMENT:
Lors de la fixation à un mur avec des montants en acier ou en bois, votre matériel de
montage doit toucher le montant à travers les emplacements des fentes en trou de serrure supérieur et
inférieur sur au moins un côté de votre présentoir pour un support approprié.
A
