Line Interactive UPS User Manual
Basic Operation and Feature Set
32
©2022 |
. All rights reserved.
Function
Default Parameter
Battery Aging Coefficient
Set to 100.
Sleep Mode
Set to Disabled.
Sensitivity
Set to Normal (with L1 and L2 both Off).
Fault and Warning Log
Set to clear notifications for either event.
Using Main Menu > Configuration Functions > Reset Batt aging coefficient
Press the Select button to enter the reset batt aging coefficient menu. Then use Up, Down, and Select buttons to
choose Yes and reset the battery aging coefficient, if desired.
Function
Available Settings
Descriptions
Reset Battery Aging
Yes or No
Set the coefficient to Yes whenever you perform a
battery replacement to optimize your battery runtime
calculation.
Using Main Menu > Configuration Functions > Service Mode
NOTE
Service mode functions are password protected and only available when your UPS is in
Standby Mode. The default password for access is 0000 as mentioned in the previous
topic. The 0000 password is entered by default, and you must press the select button to
verify each password character. For more information about status modes, see
“Understanding Your UPS Status Modes” on page
Press the Select button to enter the service mode menu.
Use Up and Down buttons to scroll and the Select button to choose from the following service mode functions.
Function
Available Settings
Descriptions
Output Voltage
110V, 120V, or 127V
Set the output of your UPS to one of the available
voltage settings.
Load Control
Disable or Enable
When load control is enabled, you can turn the bank or
outlets On or Off from the LCD screen, or from direct
or remote connections. When disabled, all bank and
outlets are locked in their current state.
Password Setup
0000 – 9999
Select a four-digit password from 0000 – 9999 used
when accessing and modifying service mode function
settings.
