Ju
ne
20
18
Legrand PDU User Guide 213
Placeholder
Definition
[SENSORTHRESHOLDNAME]
The name of the threshold being crossed
[SENSORTHRESHOLDVALUE] The value of the threshold being crossed
[SMARTCARDID]
The id of a smart card
[SMARTCARDTYPE]
The type of a smart card
[SMTPRECIPIENTS]
The list of recipients, an SMTP message was sent to
[SMTPSERVER]
The name or IP address of an SMTP server
[SYSCONTACT]
SysContact as configured for SNMP
[SYSLOCATION]
SysLocation as configured for SNMP
[SYSNAME]
SysName as configured for SNMP
[TIMEREVENTID]
The id of a timer event
[TIMESTAMP]
The timestamp of the event occurrence
[TRANSFERSWITCHREASON] The transfer reason
[TRANSFERSWITCHSENSOR] The transfer switch sensor name
[TRANSFERSWITCH]
The transfer switch label
[UMTARGETROLE]
The name of a user management role, an action was
applied on
[UMTARGETUSER]
The user, an action was triggered for
[USERIP]
The IP address, a user connected from
[USERNAME]
The user who triggered an action
[VERSION]
The firmware version the device is upgrading to
Note: In case you need to type any square brackets "[" and "]" in the custom message for non-placeholder
words, always add a backslash in front of the square bracket. That is, \[ or \]. Otherwise, the message sent
will not display the square brackets.
Editing or Deleting a Rule/Action
You can change the settings of an event rule, action or scheduled action, or delete them.
Exception: Some settings of the built-in event rules or actions are not user-configurable. Besides, you cannot
delete built-in rules and actions. See
Built-in Rules and Rule Configuration
Available
Actions
(on page 196).
To edit or delete an event rule, action or scheduled action:
1. Choose Device Settings > Event Rules.
2. Click the desired one in the list of rules, actions or scheduled actions. Its setup page opens.
3. Perform the desired action.
To modify settings, make necessary changes and then click Save.
To delete it, click
on the top-right corner. Then click Delete on the confirmation
message.
