Ju
ne
20
18
90 Legrand PDU User Guide
The right side shows the current and voltage data per phase. For a single-phase device, it shows only one
line, but for a three-phase device, it shows three lines (L1, L2 and L3).
Inlet data from top to bottom includes:
RMS current (A) and rated current
The smaller, gray text adjacent to RMS current is the rated current.
A bar showing the RMS current level
RMS voltage (V)
The RMS current bars automatically change colors to indicate the current status if the thresholds have been
enabled. To configure thresholds, see
Inlet
(on page 98).
Status
Bar colors
normal
above upper warning
above upper critical
Note: The "below lower warning" and "below lower critical" states also show yellow and red colors
respectively. However, it is not meaningful to enable the two thresholds for current levels.
Dashboard - OCP
Availability and total number of OCPs depend on the models.
Each OCP's link:
To view more information or configure individual OCPs, click the desired OCP's index number, which is C1,
C2 and the like, to go to its setup page.
Each OCP's power data:
OCP data from top to bottom includes:
RMS current (A), and rated current
Smaller gray text adjacent to RMS current is each OCP's rated current, such as "16A" shown in the
above diagram.
