AL2038 Series
Round Fixture Box
AL2044 Series
Deep Device Box
AL2047 Series Shallow Switch &
Receptacle Box
TO INSTALL:
1. Attach back plate to 2x4 outlet utility box or mounting surface.
2. If back plate is not attached to box, use cover to close opening.
3. 1/2" or 3/4" conduit connections may be connected to back cover.
4. Slide AL2000B base raceway into slot of back plate. Tighten set
screws to secure connections and for ground continuity.
AL2011 90° Flat Elbow
AL2017 Internal Elbow
At 90° turn on same surface, position AL2011 Flat Elbow at end
of AL200B base. Position next base section onto other end of
AL2011. Center coupling over base joints and over base joints
and tighten screws. Install fitting cover after wiring.
Install AL2017 to raceway base BEFORE mounting raceway
base. Fasten section to surface joints, tighten set screws.
Center coupling over base and tighten screws. Install
fitting cover after wiring.
5. Twist out KOs in cover section where raceway enters.
Attach cover with screws.
6. Attach device ( if required) to cover section.
7. Install standard cover plate.
AL2015 Tee Elbow
AL2018 External Elbow
AL2015 Tee Fitting, position fitting at end of AL2000B base.
Install other base section to other end of fitting. Center
couplings on joints and tighten screws. Install fitting
cover after wiring.
At 90° outside corner, position AL2018 External Elbow at end
of joints and tighten screws. Install fitting cover after wiring.
AL2416 Cross Elbow
AL2416 Cross Elbow, position fitting at end of AL2000B base.
Install other base sections to other ends of the fitting.
Center couplings on joints tighten screws. Install
cover fitting after wiring.
AL2000WC Wire Clip
For retaining wires in long raceway run, Snap-in AL2000 WC
Wire Clip approximately 30" apart into AL2000B base.
