www.qmotionshades.com Pensacola FL, 32514 1 -877-849-6070 1
PN 9000228
QIS Wall Switch
Programming Instructions
FIRST TIME SETUP
1.
INSTALL SHADE
following appropriate installation instructions
2.
CONNECT
POWER SUPPLY
to Power Communication Panel
3.
CONNECT SHADE
to Power Communication Panel using network cable
_
(Shade will JOG on initial power-up)
4.
CONNECT WALL SWITCH
to Power Communication Panel using network cable
PAIRING / LEARNING WALL SWITCH
(or Channel)
1.
PRESS
both
UP
and
PRESET 1
at the same time
(Shade will JOG in response)
2.
TUG
the
HEMBAR
6-10 inches
(Shade will JOG in response and is now paired)
UNPAIRING / UNLEARNING WALL SWITCH
(or Channel)
1.
PRESS
both
DOWN
and
PRESET 2
at the same time
(Shade will JOG in response)
2.
TUG
the
HEMBAR
6-10 inches
(Shade will JOG in response and is now unpaired)
Dual Channel
Wall Switch
IMPORTANT
Read and understand each section before performing required steps
When using a Dual Channel Wall Switch, the left button column corresponds to Channel 1. The right button column
corresponds to Channel 2 as shown in the diagram below.
CH 1
CH 2
Single Channel
Wall Switch
When learning new positions, the button currently being programmed (after Step 3. TUG) will not send commands to the shade.
Example 1:
When learning a new PRESET 1 position, pressing PRESET 1 will do nothing (after Step 3. TUG). The shade can still be
adjusted using the UP and DOWN buttons.
Example 2:
When learning a new upper limit position, the UP button is semi-disable. Only by pressing the UP button 3 times will the
shade move to the up position (or manually roll the shade up by hand). After Step 5 all buttons resume full functionality.
SETTING UPPER AND LOWER LIMITS / LEARNING A NEW POSITION
(Must use paired Wall Switch)
1.
PRESS
the
(UP, DOWN,
or
PRESET)
button that will be programmed (Shade will move to selected position)
2.
PRESS
and
HOLD
the same
(UP, DOWN,
or
PRESET)
button
UNTIL
shade
JOGS
3.
TUG
shade
6-10 inches
(Shade will JOG in response)
4.
ADJUST
shade to desired position ( Use
UP/DOWN
buttons or manually adjust shade by hand)
5.
PRESS
and
HOLD
the same
(UP, DOWN,
or
PRESET)
button (Shade will JOG when learned)
IMPORTANT
