Chapter 7: Using the Web Interface
227
Button
Function
Up
Down
Bottom
Restores to the default sequence
Next time when power cycling the PX3TS, it will turn on all outlets based on the
new outlet order.
The new order also applies when performing the power-on or power-cycling
operation on partial outlets.
To set a power-on delay for any outlet:
1.
On the same outlets list, click the 'Delay' column of the outlet that requires
a wait after it is turned on.
2.
Type a new value in seconds.
3.
Click Save.
PX3TS will insert a power-on delay between the configured outlet and the one
following it during the power-on process.
Setting Non-Critical Outlets
Outlets that are turned off when load shedding is activated are called
non-critical outlets. Outlets that are not affected by load shedding are called
critical outlets. See
Load Shedding Mode
(on page 229).
Per default, all outlets are configured as critical.
To determine critical and non-critical outlets:
1.
On the Outlets page, click
> Load Shedding Setup.
2.
To set non-critical outlets, select the checkboxes of those you want.
Summary of Contents for Raritan PX3TS
