Using the PRO3X Command Line Interface (CLI)
PRO3X User Guide
–
Command Line Interface (CLI)
12 of 182
Querying Available Parameters for a Command
If you are not sure what commands or parameters are available for a particular type of CLI command or its syntax, you can
have the CLI show them by adding a space and the help command (?) or list command (ls) to the end of that command. A list
of available parameters and their descriptions will be displayed.
The following shows a few query examples.
To query available parameters for the "show" command:
#
show ?
To query available parameters for the "show user" command:
#
show user ?
To query available role configuration parameters:
config:#
role ?
To query available parameters for the "role create" command:
config:#
role create ?
Showing Information
You can use the show commands to view current settings or the status of the PRO3X device or part of it, such as the IP
address, networking mode, firmware version, states or readings of internal or external sensors, user profiles, and so on.
Some "show" commands have two formats: one with the parameter "details" and the other without. The difference is that
the command without the parameter "details" displays a shortened version of information while the other displays in-depth
information.
After typing a "show" command, press Enter to execute it.
Note: Depending on your login name, the # prompt may be replaced by the > prompt.
Network Configuration
This command shows all network configuration and all network interfaces' information, such as the IP address, MAC address,
the Ethernet interfaces' duplex mode, and the wireless interface's status/settings.
#
show network
Summary of Contents for Server Technology PRO3X
Page 1: ......
