Doc No. FM0725 issue C Page 1
169MHz Telecare Devices
Gas Detector
__________________________________________________________________________________________________________
•
Compatible with Reach at-home alarms, Advent xt warden call,
Altec Response and Touchsafe Pro Nursecall systems
•
Alarm at 10% of LEL (Lower Explosive Limit)
•
85dB @ 1m sounder
•
3 Indicator lights: green power, red alarm & yellow fault
•
Requires 240V AC mains supply
•
Power consumption: <6.5 Watts
•
Transmitter low battery warning
•
Test/Hush button
•
Complies with EN50194:1:2009
•
Backplate dimensions: 175 x 140mm (depth = 43mm)
•
Weight: 375 grams
•
Product Code: ZXT486
Where should a Gas Detector be fitted?
A gas detector should be fitted in the room where a gas escape is most likely to occur.
For most installations the most likely source of a gas escape will be the cooker in the kitchen.
Choosing a Location
Natural gas is lighter than air therefore the gas detector should be wall mounted above
the level of a possible gas escape but not more than 30cm from the ceiling.
The gas detector should be located between 1 and 5 metres from the gas appliance. It must not be located inside a cupboard,
behind a curtain, directly above the cooker or sink, next to a door or window or near an extractor fan.
The gas detector should be within 5 metres of a mains supply otherwise the cable provided will need replacing.
Typical Tools Required
Be careful when using step ladders
–
always face the direction you are working.
Always make sure the correct drill bits and screwdrivers are used.
Installation
1.
IMPORTANT:
BS EN50244:2016 Electrical apparatus for
the detection of combustible gases in domestic
premises states that gas detectors should be installed
via a permanent electrical connection and not using
a plug and socket.
2.
Fix the mounting plate complete with detector
to the wall using the screws and plugs provided
through the
FIXING HOLES
“
A
”.
3.
Run the mains cable to the nearest mains supply and
secure using the self-adhesive cable clips provided.
4.
The detector should be wired to the mains supply using a
flexible cable appropriately rated via a fused connection
outlet and fitted with a 3A fuse to BS1363-4 and BS1362
respectively, or according to local regulations.
5.
If choosing to use a plug and socket then fit the plug-wrap,
plug-in and switch on the mains supply.
Check the following sequence occurs; all 3 indicators light
and the unit sounds a single chirp. The 3 indicators then
light in turn and cycle 4 times. The unit is operating
when the
GREEN
Power
light is lit steady.
6.
Press and hold the
TEST/HUSH
button for 1 second.
The red light will flash 4 times followed by the yellow
light 4 times accompanied by the audible alarm
sounding 8 times.
“
A
”
“
A
”
“
A
”
Tynetec and Aidcall are business units of Legrand Electric Ltd
Unit 10 Cowley Road, Blyth Riverside Business Park, Blyth
Northumberland, NE24 5TF. Tel:
01670 352 371
Fax:
01670 362 807
Email:
sales@tynetec.co.uk
Web
:
www.tynetec.co.uk
“
A
”
4 x FIXING HOLES
“
A
”
GAS ENTRY
POINT
INDICATOR LIGHTS
AUDIBLE
ALARM
TEST/HUSH
BUTTON
REPLACE
BY DATE
FIT PLUG
WRAP
