3
No: IS-00722 Rev. 2
INSTALLATION
Installation of Vantage products should be performed or supervised by a Certified Vantage Installer. Installation kits for Equinox 73-III
touchscreens are compatible with global electrical and installation standards. For new construction or retrofit installations. Please see
the additional installation sheets referenced below for Equinox 73-III’s installation preparation.
See Standard, Easy Retrofit, and TPT650 retrofit, respectively
Click on the install method wanted:
•
Equinox 73 LCD Standard_EQ73ST-INSTALL_install_IS-0545.pdf
•
Equinox 73 LCD Easy-Retrofit_EQ73ER-INSTALL_install_IS-0697.pdf
1. Connect Equinox 73-III to Ethernet PoE
2. Insert the Equinox 73-III into the mounting ring from the mounting option selected
- Make sure the Equinox 73-III’s four spring clips lock to mounting option selected: Standard, Easy-Retrofit,
or Retrofit install options
CONFIGURATION
1. Highlight the station in Design Center and click
Configure Stations
2. Station displays configure mode and touch to configure
3. When configured station goes back to ready until programmed
-OR-
4. The station may also be configured by typing the serial number in the project file, using this method the station will automatically
be configured when the system is programmed.
DEVICE AND INFO SETTINGS
Device Settings
are accessed through the
Profile
pages.
Press the
Profile
button, (
my home,
upper right, in this example).
Press the
settings
button.
The first time
settings
is pressed the screen will go to the
dashboard edit screen.
Pressing the upper left area on the dashboard page,
opens the
Settings
thumbnail selections at left.
Select the
device
option from the four choices.
NOTE:
The other three choices are covered in the
Equinox Widgets_install.pdf
installation sheet and in
Design Center
Help
.
1.
2.
3.
4.
5.
