ProLAN 16 & 24
Power Strip Installation
1061 South 800 East, Orem, UT 84097
800.555.9891 801.224.0355 fax
www.vantagecontrols.com
Information in this document is subject to change at any time without notice
Revision: O
October 24, 2007
P/N
INSTProLANPOWER-PL
Kit Contents
1 Power Strip w/ 8 Outlets
2 Wire Nuts
1 Grounding Screw
1 Instruction Manual
The ProLAN 24 power strip is a 8 outlet power distribution device designed specifically for the ProLAN 24.
The ProLAN 16 power strip is a 6 outlet power distribution device designed specifically for the ProLAN 16.
The electrical wiring connections are the same for both units.
WARNING:
TO BE INSTALLED AND/OR USED IN ACCORDANCE WITH THE APPROPRIATE CODES AND REGULATIONS.
WARNING:
TO AVOID FIRE, SHOCK, OR DEATH; TURN OFF THE POWER AT THE CIRCUIT BREAKER OR FUSE AND TEST
THAT THE POWER IS TURNED OFF BEFORE WIRING.
WARNING:
TO BE WIRED BY AN APPROVED (CERTIFIED) ELECTRICIAN.
CAUTION:
USE THIS DEVICE ONLY WITH COPPER OR COPPER CLAD WIRE.
INSTALLATION
It is recommended that the ProLAN power strip be wried on its own 15A circuit. Vantage supplies the necessary
termination supplies to correctly wire this power strip in accordance with UL and NEC codes.
1. Make certain that the power is off at the breaker or fuse panel. TEST to be certian.
2. Pull the electrical wire through the strain relief as shown in figure 1. It is important to leave roughly 11
inches of electrical wire in the outlet strip tray to allow for easy assembly once connected.
3. Strip 10 inches of electrical wire protective jacket and cinch the strain relief (figure 2).
4. Remove 1/2” insullation from the Black (Hot) and White (Neutral) on both the electrical supply cable
and the ProLAN power strip (figure 3).
5. Connect the Green ring terminal wire and electrical supply ground cable (typ. bare copper) to the
ground screw in the power strip tray as shown (figure 4).
6. To connect the White wires twist the metal leads together. Place a wire nut over the intertwined length
of wire and twist clockwise until tight as shown (figure 5). Pull on wire nut to make certain it is tight.
7. To connect the Black wires twist the metal leads together. Place a wire nut over the intertwined length
of wire and twist clockwise until tight as shown (figure 5). Pull on wire nut to make certain it is tight.
8. The natural direction of the wires should allow the power strip to lay flush as shown (figure 6)
9. Using the supplied screws, fasten the top outlet assembly to its mating tray as shown (figure 7).
©Copyright 2007 by Vantage/Legrand All Rights Reserved.
