2
No: IS-00711 – Rev. A
•
Station reset – simultaneously press and hold both mechanical buttons for three seconds until the screen goes dark, then release
•
Station reset into
Service Mode
– simultaneously press and hold both mechanical buttons for ten seconds
- Service mode is automatically used when updating firmware from Design Center
- If the application code is corrupt it may cause the screen to lock, preventing Design Center from updating or reloading the
firmware. Use this option to reboot the screen to service mode allowing Design Center to update the corrupted firmware.
- To manually exit
Server Mode
use the
Station Reset
option (above)
Description
Specification
Dimensions, HWD (at wall surface)
4.9” x 3.44” x 0.44” (124mm x 87mm x 11mm)
Dimensions, HWD (overall)
4.9” x 3.44” x 1.1” (124mm x 87mm x 28mm)
Finished Weight
8.8 oz. or 249.5g
Power
Ethernet with PoE, PoE+, 5W
Wiring Connections
Communication and power: PoE/PoE+ via Ethernet RJ45
Surge Suppression
Yes
Maximum Gangs
Single gang only
LCD Button Status
Automatic (white = off, orange = on)
Mounting
US/European style, single gang, wall boxes or low-voltage brackets
Addressing
Self-addressing through software
Finish
Trim: Titanium, Touchscreen: Black glass
Glass Surface
Chemically strengthened
Ambient Operating Temperature
32-95°F (0-35°C)
Ambient Operating Humidity
5-95% non-condensing
CE/FCC Compliant
Yes
SPECIFICATIONS
SYSTEM REQUIREMENTS
Equinox 41-LCAP is compatible with InFusion Design Center version 3.8 software or higher. For new projects it is recommended that
firmware and software be kept to the most current release.
INSTALLATION
Installation of Legrand products should be performed or supervised by a certified Legrand installer. The Equinox 41-LCAP
touchscreen installs into US/European style, single gang, wall boxes or low-voltage brackets. Connect to local network via PoE/PoE+
RJ45 Ethernet connection.
FEATURES AND OPERATION OVERVIEW
(continued)
NOTE:
If buttons are held in too long, the screen will boot to
service
mode
, and will not load the application code. Repeat manual reboot
– without holding buttons to long – to clear this mode.