13
_________________________________________________________________________________________
5.2 Overturning hazard
-
Safe working load, number of persons and additional load on the platform must never
be exceeded.
-
When wind speed is equal to or greater than 12,5 m/s - 28 mph, the use of the access
platform must be discontinued immediately and the platform must be lowered down to
transport position.
-
Ensure that the access platform is used on dry, solid, level ground only. The ground is
solid enough if it can carry min. 3 kg/cm
2
. On softer grounds use extra support plates
under the outriggers (plate dimensions 400 x 400 mm).
-
Do not use a ladder, chair, stool, scaffolding or by any other means try to increase
reach capability of this access platform.
-
In case the platform has got stuck or jammed, or it is too close to a building or a wall to
be moved, do not try to release the platform by operating the controls. All persons must
leave the platform first (with the help of a rescue service of fire brigade if necessary),
only after that one can try to lower the platform by using the emergency lowering.
-
Do not try to increase the area of the platform or the load. Increasing of the area
exposed to wind will weaken the stability of the access platform.
-
Weight must be equally distributed on the platform. Make sure that additional weight
cannot shift on the platform.
-
Do not drive on gradients that are steeper than the max. values given for this access
platform and for the slope.
-
Never use this access platform as a crane or an elevator. This access platform is
intended for lifting of the max. allowed number of persons and additional load only.
-
Check and make sure that all tyres are in good condition. If the tyres are air filled make
sure that there is correct pressure in the tyres.
-
In order to ensure the safe operation of this access platform the manufacturer has
conducted approved tests for the
LEGUAN 125
in accordance with the standard EN280
+A2 : static stability test in accordance with paragraph 6.1.4.2.1 and dynamic overload
tests in accordance with paragraph 6.1.4.3 of the EN280 +A2.
5.3 Falling hazard
-
The operator(s) must always wear certified safety harnesses when operating this access
platform. The harnesses must be connected to the fastening point at platform mounting
bracket.
-
Do not stretch or reach out over the handrails. Stand steadily on the platform floor.
-
Keep platform floor clean.
-
Always close the platform gate before starting operation.
-
Do not drop or throw any material down from platform.
-
It is not allowed to go to or step out from the platform when the booms are lifted.
5.4 Collision hazard
-
Adjust the drive speed so that it is safe with regard to the ground conditions.
-
The operator must follow all regulations concerning the use of safety equipment on the
work site.
-
Make sure that there are no overhead obstacles on the work site that could prohibit
lifting of the platform, or objects that might cause a collision.
-
Do not operate this access platform in the working area of another overhead lifting
device or similar equipment that is moving, unless this lifting device is secured so that
there is no risk of collision.
-
Beware of crushing hazard when holding the handrail of the platform in an eventual
collision situation.
-
When operating the machine beware of eventual limited visibility and trapping hazard.
