4
LEHLE GmbH · Germany · www.lehle.com · support@lehle.com
The LEHLE P-SPLIT III combines passive
splitting with the highest possible signal
fidelity.
Its applications range from splitting sig-
nals and eliminating hum, to balancing
and re-amping along with any signal
routing that requires a clean signal free
from noise.
At its core is the high-end LEHLE TRANS-
FORMER HZ, which galvanically isolates
the two outputs, eliminating any possibil-
ity of ground loops. The LEHLE TRANS-
FORMER HZ was specially designed for
use with high-impedance signals but also
splits low-impedance signals with un-
compromising sound quality. The signal
can be picked off either symmetrically or
asymmetrically from the ISO output.
By using the phase inverter switch with
gold-plated contacts you can flip the sig-
nal phase at the ISO output, preventing
phase cancellation from impairing signal
reproduction.
The classic application for the LEHLE P-
SPLIT III is splitting an input signal to two
outputs, enabling you to connect an in-
strument to two devices, which may, for
example, be two amplifiers, or an amp
and a mixer/recording unit (PC/DAW).
Thanks to its ability to pick off the bal-
anced signal on the ISO output, the LEH-
LE P-SPLIT III is also eminently suitable for
use as a high-quality compact DI box for
all types of signal.
Another useful application for the LEHLE
P-SPLIT III is as a hum suppressor. Fre-
quently background noise, caused by
ground loops occurs when two electronic
devices are connected to each other. The
LEHLE P-SPLIT III provides a simple, but
extremely effective remedy when installed
between the two units. Using the ISO out-
put, the devices are galvanically isolated
and background noise becomes a thing
of the past.
You can even use the versatile LEHLE P-
SPLIT III as a passive mono summing unit
for a stereo signal by using the DIR output
as second input.
And just in case you are looking for a
power connection: the LEHLE P-SPLIT
III performs all its functions without any
need for a power supply.
INTRODUCTION
