15
Brake System Modification- Rear
NOTE: For ABS Disable see pg. 47
1.
See Fig. 1.
Disconnect inner rear brake line
(upper line on caliper).
2. Disconnect upper line at caliper and discard
brake line.
NOTE: Allow brake line to drain before blocking
off
.
3. Block off inner brake line using the following
hardware.
•
(1) M10 Banjo Bolt– CB6001
•
(2) Copper Banjo Washers– GC6002
•
(1) 1/2” Spacer– S001067
4.
See Fig 2.
Using cable ties, secure discon-
nected brake line to top of crossbar on frame.
5. Disconnect lower brake line from caliper.
6.
See Fig. 3
. Route brake line above plastic
panel on RH side below shock compressor
location.
7. Drill 1/4” hole in plastic and mount brake line
using the following hardware that was saved
from disassembly.
•
(1) Original Front Brake Line Clamp
•
(1) Original Upper Amplifier Mounting Bolt
•
(1) Original Saddlebag Washer
•
(1) M6 Lock Nut– CN1902
PREPARING THE MOTORCYCLE
Fig. 1
Fig. 2
Disconnect inner
brake line at fitting
Fig. 3
Secure line
above crossbar
Mount to
plastic with
original clamp
Block off line
