1997-2001 FLH Renegade– Rev. 3
Body Installation
1.
See Fig. 1.
Bolt side cover bracket to body using
1/4” X 1” button head bolts and 1/4” flat washers
on outside of body. Use 1/4” fender washers and
1/4” lock nuts on inside of fender.
2. Route emergency trunk release cable along H-D
frame and secure behind LH side cover.
3. Set body roughly in place on trike frame.
4.
See Fig. 2
. Attach side covers to frame and body
in following order:
•
Lower pin, then upper pin into side cover
mount
•
Upper forward pin into motorcycle frame
4. Center body from side-to-side and front-to-back
using a carpenter square against tire. Make sure
side covers have an even gap on both sides and
do not rub on body.
5. From underside of body, drill a 1/4” hole in body
through each of four mounting tabs. Keep hole
centered in slot of each of tabs.
6. Fasten body to Lehman frame as follows: Head of
bolt will be inside trunk.
•
(4) 1/4” x 1-1/2” Button Head Bolts- CS4031
•
(4) 1/4” x 1 1/4” Fender Washers- CW2108
•
(4) Foam Sealing Washers- FG1002
•
(4) 1/4” Flat Washers- CW2007
•
(4) 1/4” Lock Nuts- CN3041
7.
See Fig. 5.
Install upper body braces (LB1235) by at-
taching slotted side on top of Lehman frame using the
following hardware. Leave hardware loose.
•
(2) Body Brace– LB1235
•
(2) 5/16” x 1” Bolts– CB1161
•
(2) 5/16” Lock Washers– CW2047
•
(2) 5/16” Flat Washers– CW2010
8. Slide bracket against trunk, mark and drill 1/4” hole.
9. Attach bracket to body using the following hardware.
•
(2) 1/4” x 1-1/2” button head bolts- CS4031
•
(2) 1/4” x 1 1/4” fender washers CW2108
•
(2) Foam Sealing Washers FG1002
•
(2) 1/4” Flat Washers- CW2007
•
(2) 1/4” Lock Nuts- CN3041
10. Tighten 5/16” hardware into place on trike frame.
11. Verify all body mounting hardware is tight.
28
Fig. 1
LH Side
cover bracket
Fig. 2
Side cover installed
Fig. 3
Body brace attached
to frame
