BD
A Cap
tur
a 100 MIF
ARE® / 22020-06-29 (GB)
2
GENERAL DESCRIPTION
The Captura 100 MIFARE® lock is a battery-operated electronic furniture lock based on RFID technology, which is
intended for use in living and office areas inside buildings. These operating instructions provide you with information
on how to operate the locking system without errors. Keep the operating instructions in an easily accessible place.
Improper use can destroy the locking system and lead to the loss of any warranty claims.
Please be sure to observe all warnings and read the operating instructions completely before proceeding with
installation, commissioning and programming. It may be possible to use our locks and locking systems together with
mechanisms made by other manufacturers, but their compatibility must be checked in each individual case. We
cannot accept any liability for damage or loss due to incompatibility.
Wording and graphics have been prepared with care. However, no liability will be assumed for any mistakes that may
have occurred. Technical specifications as well as the scope of items in the system are subject to change without
notice.
CAUTION:
The lock can be configured with master and programming cards or with the LEHMANN Management
Software LMS. These operating instructions describe how to use the locking system with master and
programming cards. The software LMS and the corresponding documents can be found at https://
lms.lehmann-locks.com.
SAFETY PRECAUTIONS
U
U
Pack the battery for the transport of the lock so that no short circuit can occur (risk of explosion and fire).
U
U
When replacing the battery, make sure that the polarity and position of the battery is correct!
U
U
Dispose of used batteries properly!
U
U
Do not heat batteries, take them apart or short-circuit them!
U
U
Never throw batteries into open fire!
!
TECHNICAL SPECIFICATIONS
Frequency
13,56 MHz
National legislation about permissible radio frequencies must be observed.
RFID technology
MIFARE® Classic, MIFARE® DESFire® EV1, EV2
Supported
transponders
Compatible with the following RFID transponders:
• MIFARE® Classic / • MIFARE® DESFire® / • ISO 14443A
Existing transponders must be checked for compatibility!
Energy supply
1 x CR123A
Operating temperature
-5 °C to +60 °C
Storage temperature
-25 °C to +70 °C
Reading distance
Up to 30 mm with LEHMANN user cards (MIFARE® DESFire® EV1). Other transponders
may have a shorter reading distance and must be checked in advance. The material of the
furniture can influence the reading distance. A test on the furniture regarding the reading
distance is therefore recommended.
Type designation
L3NF13CX