DELTA
Installation Manual
Edition July 2013
DELT
∆
∆
∆
∆
platform lift
page 16 of 24
Adjustment of the platform inclination
To adjust the platform horizontally, change the
adjustment screws as shown in the picture. Check in
loaded condition! Counter the adjusting screw with
the counter nut after successful adjustment.
Caution:
Check if
both
adjusting screws are
supporting the platform!
After changing the platform inclination please check
the platform mechanism:
Between the hook and the slider should
be around 2mm gap. This can be
adjusted by moving switch S11m.
S11p must be properly pressed when
platform is open (it must click when
pressed). Otherwise adjust.
S11o must be pressed when platform is
closed. Otherwise adjust.
Between the main bearing and the
platform sliding mechanism a minimum
distance of 1-2mm must be given. This
can be adjusted by changing the length
of the ball bearing connection between
the platform and the carriage. This is
important so that mechanical force of the
platform in an unfolded position is not
directly carried forward to the mechanical
parts inside the platform, but rather held
by the adjusting screws!
If barrier arms are not horizontal open
the screw shown in the illustration, adjust
the barrier and lock the adjustment with
the screw again.
Adjustment
Main bearing
Extend ball
bearing
1-2mm
distance
Necessary 2mm gap
Hook
S11o
S11p
S11m
Slider
Barrier arm
adjustment
