Operating instructions
Operating the SuperVario® X
11
2.4 Mounting the control panel
Caution!
Ensure that the cable is not routed over any sharp
edges.
1. Mount support for the control panel in the vehicle cabin.
2. The supplied battery cable must be installed, even if there is a socket
available, as our battery cable is 4 mm².
• Connect terminal
2
to the negative terminal of the battery (not to
the bodywork).
• Connect terminal
3
(with fuse
4
) to the positive terminal of the
battery. Run the end of the cable with the socket into the carrier
vehicle.
3. Plug the spreader cable into the 16-pin plug of the control panel.
Your device is now ready to operate.
1
2
3
4