Operating instructions
Operating the SuperVario® X
18
3.9 Setting the agitator
Because grasses, in contrast to seeds with their grain structure, have very
poor flow properties, the agitator must be adjusted accordingly.
Setting for grasses:
Upper stirring shaft on one side
Lower stirring shaft at a ratio of 2/3 or 1/3
Setting for remaining products:
Upper stirring shaft dismantled
Lower stirring shaft at a ration of 1 to 1
Danger!
Do not adjust the stirring shafts if the agitator is installed,
which otherwise could lead to bearing failure on the
motor.
1. Remove the hopper.
2. Firmly hold the spreading disc and turn the agitator to the right.
Caution: Left-hand thread!
3. Appropriately install the stirring shafts.
3.10 Empty indicator
The empty indicator indicates when the spreading material in the hopper drops
below a certain level.
The message "Hopper empty" flashes on the display for approx. five seconds.
At the same time, eight warning signals sound and the red LED on the empty
indicator flashes.
To switch off the empty indicator, briefly close the slide or switch off the
spreader.
