Page 244
Job Editor
Group 8
Release 2.02
JET3 Series
ATTENTION
For technical reasons the
<Contrast
> function works only for complete
strokes (vertical printed dot line). This means that objects positioned
above or below the object with the contrast Attribute will also be affected
from the setting.
Example:
In a two line printout the contrast
attribut was assigned to the object
in the lower line only. Nevertheless
the objects in the upper line which
are positioned directly above the
object with the contrast attribut will
be also affected from this setting.
1. Line:
Leib
inger In
k-Jet
2. Line:
Printer
Note:
The higher the contrast set the lower is the max. printing speed!
8.4.2 Bold level - Bold text
In order to set the
<bold>
attribute to a text the bold level has to be determined. There
are 8 levels available: 0
–
7. The currently value set is shown in the respective input field.
The
<bold>
attribute is created by printing additional parallel strokes to the standard dots.
Example
0 = no bold text (single strokes)
1 = 2 dots are placed parallel (2 strokes)
2 = 3 dots are placed parallel (3 strokes)
…..
7 = 8 dots are placed parallel (8 strokes)
The value set is shown on the accordant input field.
Figure 128
Object settings (Bold text)
Printout:
Standard
With bold attribut
Summary of Contents for JET3
Page 1: ...Operating Manual V2 02 Please keep for future reference ...
Page 2: ......
