For the glass cleaning procedure, the wet and dry lens cleaner
Green Clean LC-7010 is recommended (www.green-clean.at/en.html).
Clean the glass pane regularly with the recommended cleaning tissue:
•
Switch off instrument and remove the battery.
•
Washing hands is necessary in order to avoid grease on the cleaning
tissue.
•
Better, use gloves to avoid finger oil on the glass.
•
Then use the wet lens cleaning tissue (Green Clean LC-7010) until there is
only a thin film of detergent visible.
•
After that use the dry lens cleaning tissue (Green Clean LC-7010) to
remove any remaining detergent.
•
If any smears from cleaning are visible against back light, repeat the pro-
cedure.
•
Do not use air from the pneumatic power system as this is always slightly
oily!
Dry the product, the container, the foam inserts and the accessories at a
temperature not greater than 40 °C and clean them. Do not repack until
everything is completely dry.
Keep plugs clean and dry. Blow away any dirt lodged in the plugs of the
connecting cables.
13.3
Transport
Never carry the product loose in a road vehicle, as it can be affected by shock
and vibration. Always carry the product in its container and secure it.
Handcarrying the BLK2FLY
•
Hold it either on the mainbody or inner arms
•
Prevent holding the BLK2FLY at the shrouding or outer arms
•
Watch out not to touch/scratch the LiDAR lighthouse, camera and tof
lenses
•
Watch out for the propellers when folding BLK2FLY. Do not scratch the
lighthouse.
When transporting the product by rail, air or sea, always use the complete
original BLK2FLY packaging, container and cardboard box, or its equivalent, to
protect against shock and vibration.
Discharge batteries to around 30%.
Damp products
Cables and plugs
Transport in a road
vehicle
Shipping
Shipping batteries
Care and Transport
107
