Getting Started
PaveSmart 3D UM
25
a)
Dashboard/Error messages
: the specific icon flashes yellow if a warning is detected or
flashes red if an error occurs. By pressing on the specific button additional information and
troubleshooting tips will be displayed.
1.) MPC1310 messages
2.) Communication messages
3.) Sensor messages
4.) Machine messages
b)
Corrections
: indicates the required corrections for steering/position deviation, elevation and
cross slope. For example, if the Set value is 1.0 and the Actual value is 1.1 (in m or ft), the
screed is too high, and machine has to lower the tow arm until the set- and actual values
match (1.0). The values and settings are exactly the same as those values displayed on the
machine controller (e.g. MOBAmatic, Vögele NaviTronic) and can be changed manually on the
controller using the height correction buttons (Set Value).
c)
Screed Information
: for Vögele pavers only, indicates the corrections for the Screed Edge
left and right. Inside the box the current total width of the screed and width for left side of
the screed (1.250 m) and for the right side of the screed (1.260 m).
d)
Information
: provides information about the work progress.
•
Stationing
shows current Stationing or Chainage (in m or ft).
•
Speed
indicates current Speed of the machine (in m/min or ft/min).
•
Layer Offset
shows the actual layer offset of PaveSmart 3D (Elevation Offsets).
•
Working Slope
shows the current Working Slope, which is the Design Slope at the
current position plus the Slope Offset.
e)
Design display
: shows the whole project and the current machine position. Click on the Map
to select the ReferenceLine, SlopeLine and ScreedEdge Lines for active control.
f)
opens the Sensor dialog to manage Robot and GPS sensors.
g)
opens the Offset dialog to set the working mold offsets relative to the selected
ReferenceLine, SLopeLine and ScreedEdge lines.
Summary of Contents for MCR-900
