Care and Transport
109
5.3
Cleaning and Drying
General
Blow all dust off. Use only a clean, soft, lint-free cloth for cleaning. If necessary, moisten
the cloth with water or pure alcohol.
Do not use other liquids; these may attack the polymer components.
Damp products
Dry the product, the transport container, the foam inserts and the accessories at a temper-
ature not greater than 40 °C / 108 °F and clean them. Do not repack until everything is
completely dry.
Never leave wet components in a sealed carry-case for extended periods of time - for
example overnight. Always leave the carry-cases open overnight in a warm location, to allow
moisture to evaporate fully before resealing carry cases.
Cables and plugs
Keep plugs clean and dry. Blow away any dirt lodged in the plugs of the connecting cables.
Connectors with dust
caps
Wet connectors must be completely dry before attaching the dust cap.
5.4
Maintenance
Control measurements
During paving, milling or trimming, control measurements must be made regularly to deter-
mine possible changes in the machine geometry or in the sensors. Accuracy is influenced by
jobsite conditions such as temperature, visibility and material consistency and can be
adjusted through offsets.
Summary of Contents for MCR-900
