Rugby 620, Troubleshooting
35
Rugby does not
turn on.
The batteries are low or dead.
Check the batteries and
change or charge the batteries
if necessary. If the problem
continues, return the Rugby to
an authorised service centre
for service.
The distance of the
laser is reduced.
Dirt is reducing the laser output. Clean the windows of the
Rugby and the receiver. If the
problem continues, return the
Rugby to an authorised service
centre for service.
The laser receiver
is not working
properly.
The Rugby is not rotating. It may
be levelling or in Elevation Alert.
Check for proper operation of
the Rugby.
Refer to the receiver
manual for more infor-
mation.
The receiver is out of usable
range.
Move closer to the Rugby.
The batteries of the receiver are
low.
Change the receiver batteries.
Elevation Alert
function is not
working.
The Elevation Alert function is
disabled.
The Elevation Alert function is
enabled or disabled by
pressing the following button
combination:
With Rugby turned on and
rotating, press and hold the Up
and Down Arrow buttons. Then
press the Automatic/Manual
Mode button to enable or
disable the Elevation Alert
function. The Rugby beeps
once to indicate the change.
The Rugby does
not switch to
Manual Mode.
The Rugby beeps
three times when
the Auto-
matic/Manual
Mode button is
pressed and does
not change to
Manual Mode.
The Manual Mode is disabled.
The Manual Mode can be
enabled or disabled by
pressing the following button
combination:
With the Rugby turned off,
press and hold both the Auto-
matic/Manual Mode button
and the Power button for
5 seconds. The Rugby will beep
five times, then give a longer
beep at the end to indicate the
change.
Problem
Possible Cause(s)
Suggested Solutions
