B. Steel wire type brake is adjusted by loosening the lock nut rotation adjustment nut.
C. After the adjustment, the lock nut must be tightened, and the brakes cannot be adjusted
too tightly. Otherwise, the brake drum is likely to be rubbed, which makes the ride very
laborious.
(7) The brake shoe must be adjusted to fully contact the side of the rim when in use and the
distance to the rim is 2mm. If the brake shoe touches the tire or does not completely touch
the rim when braking, it will cause the brake shoe to wear too fast and the brake is out of
order. When the brake shoe wears to the groove, only 1MM is left or the brake stroke
exceeds 1/1. When the distance is 2, the brake shoe must be replaced in time.
We have made every effort to ensure that the information in this manual is accurate and the
product function parameters are subject to change without prior notice.
Declaration of Conformity
The manufacturer declares that the products listed above are conform to all relevant
declarations of the Machinery Directive –2006/42/EG, Low Voltage Directive 2014/35/EU,
product safety 2001/95/EC and Dir. Electromagnetic Compatibility –2014/30/EU.
Please, find the full declaration here:
www.leicke.eu/de/products/bb12062
www.leicke.eu/de/products/bb12083
Applied technical standards: DIN EN 15194
Bicycles–Electrically power assisted bicycles DIN EN ISO 4210
Disposal
This device contains materials that must not be disposed of as household waste. Please
check local laws concerning the applicable disposal regulations.
Protect the environment by participating in recycling programs.
