background image

SAVE THESE INSTRUCTIONS

1

THIS SPA IS FOR RESIDENTIAL USE ONLY!

IMPORTANT SAFETY INSTRUCTIONS

When installing and using this electrical equipment, basic safety precautions should always be followed, including the following:

1. READ AND FOLLOW ALL INSTRUCTIONS

2. Warning

To reduce the risk of injury, do not permit children to use this product unless
they are closely supervised at all times.

3.

A wire connector is provided on this unit to connect a minimum No. 8.4mm
(8AWG) solid copper conductor between this unit and any metal equipment,
metal enclosures of electrical equipment, metal water pipe, or conduit within
1.5m (5 feet) of the unit.

4. Warning

(For permanently installed units)

All Electrical Connections Must Be Performed By A Certified Licensed
Electrician 

The electrical supply for this product must include a suitable

rated switch or circuit breaker to open all ungrounded supply conductors to
comply with all local electric codes. In addition, all 230 volt installations
must be protected by a 230 volt 3ma maximum rated Recidual Current
Detector (RCD). The main disconnect device must have a 3mm contact
gap separation and also provide all pole disconnection.

5. Danger

Risk of Accidental Drowning. Extreme caution must be exercised to prevent
unauthorized access by children. To avoid accidents, ensure that children
cannot use this spa unless they are supervised at all times. For additional
protection, select a cover which is classified by the Underwriters Laboratories
Meeting ASTM F1346-91 requirements.

6. Danger

Risk of Injury. The suction fittings in this spa are sized to match the specific
water flow created by the pump. Should the need arise to replace the suction
fittings or the pump, be sure that the flow rates are compatible.

Never operate spa if suction fittings are broken or missing. Never replace a
suction fitting with one less than the flow rate marked on the original suction
fitting.

7. Danger

Risk of Electric Shock. Install at least 1.5m (5 feet) from all metal surfaces.
As an alternative, a spa may be installed within 1.5m (5 feet) of metal
surfaces if each metal surface is permanently connected by a minimum
No. 8.4mm (8AWG) solid copper conductor to the wire connector on the
terminal box that is provided for this purpose.

8. Danger

Risk of Electric Shock. Do not permit any electric appliance, such as light,
telephone, radio, or television, within 1.5m (5 feet) of a spa.

9. Warning 

To reduce risk of injury:

A.

The water in a spa should never exceed 40°C (104°F). Water

temperatures between 38°C (100°F) and 40°C (104°F) are considered safe
for a healthy adult. Lower water temperatures are recommended for your
children and when spa use exceeds 10 minutes.

B.

Since excessive water temperatures have high potential for fetal damage

during the early months of pregnancy, pregnant or possibly pregnant women
should limit spa water temperatures to 38°C (100°F).

C.

Before entering spa, the user should measure the water temperature

with an accurate thermometer since the tolerance of water temperature-
regulating devices vary.

D.

The use of alcohol, drugs, or medication before or during spa use may

lead to unconsciousness with the possibility of drowning.

E.

Persons suffering from obesity or with a medical history of heart disease,

low or high blood pressure, circulatory system problems, or diabetes should
consult a physician before using a spa.

F.

Persons using medication should consult a physician before using a

spa since some medication may induce drowsiness while other medication
may affect heart rate, blood pressure, and circulation.

10. Warning Sign

Included with this spa is a warning sign. It is extremely important that this
sign be permanently placed in clear view of any persons using the spa.
Occasional spa users may not be aware of some of the dangers hot water
poses to pregnant women, small children, and people under the influence
of alcohol, drugs, or medication. If you did not receive a warning sign or
your sign has become damaged, please contact your spa dealer and ask
for sign number PL601035 Rev A.

Summary of Contents for Celebrity P5S3 Santo



















Reviews: