Leisure bay spas Genius G-2.5 Owner'S Manual Download

Page: 16 / 22

Personal Comfort Control Console

The Leisure Bay Personal Comfort Control Console is your direct link to the most sophisticated solid state spa control center available. With a simple
touch of the finger you can select any spa’s functions from turning on the lights to powering up the jets. This state of the art control console allows you
to program the spa’s various operating functions to suit your individual needs by following the user friendly directions which follow. Should you have any
questions regarding operations please contact your local Leisure Bay dealer.

WARNING: SHOCK HAZARD! NO USER SERVICEABLE PARTS. Do not attempt service of this control. Contact your dealer or service

center for assistance. Follow all owner’s manual power connection instructions. Installation must be performed by a certified licensed

electrician and all grounding connections must be properly installed.

G-3 Series Control

Initial Start-Up

When your spa is first activated, it will perform a self diagnostics test
showing a series of numbers followed by Pr, —F, including a 5 minutes
pump purge cycle. Also an internal 24 hour clock that keeps track of
the purge cycles starts. This test will take approximately 13 minutes.
The system is preset from the factory to heat up to 100

F, but once the

self diagnostics test is completed, it is okay to change the preset temp.

Temperature Adjustment 70

-104

When either of the temp pads

is touched once, the

LCD will flash and display the temperature which has been set. While
flashing, press the temp pad again to increase or decrease the
temperature. The temperature will change from 70

-104

F in 1

increments. After 5 seconds, the LCD automatically will display the
current spa temperature.

Jets

Press the

pads to turn the pump 1 or 2 on and off. If left running,

the pumps automatically will turn off after 15 minutes.

Freeze Protection

If the high-limit sensor detects 44

F at the heater, then all the equipment

automatically is activated to provide freeze protection. This is a normal
spa function; no corrective action is necessary. The equipment stays
on until the sensor detects 45

F at the heater. Freeze protection is

enabled regardless of the spa mode status. See also page 4.

Standby Mode

The spa can be disabled when the filter needs to be replaced. To put the

system in standby mode, press the

pad then the

pad and

the display will show “

”. All spa functions are disabled except for

freeze control. Press any panel button to resume spa operation.

Display Messages (see page 16)

Lights

Press the

button to switch the spa light On or Off.

These state of the art digital lights have various color operation modes:

1. Red

2. Yellow

3. Green

4. Aqua

5. Blue

6. Purple

7. White Party Mode: Produces Random colors and flashing

patterns

8. Color Wheel: Smooth color changing pattern.

To switch modes, simply press the

button to Off for

no less

than 2 seconds,

then On to advance the to the next mode. If they are

pressed too soon, the lights could get unsynchronized.

To synchronize, leave the lights in the off position for 4 to 8 seconds,
the lights will flash three times at which point all the lights will be at the
same mode.

These lights have a memory that when switched off for more than 8
seconds, they will power up in the last mode that was selected. This
allows the user to leave the lights in a favorite mode without having to
hunt for it when powering up the lights.

Spa Water Maintenance

The spa water is constantly maintained by a 24HR circulation pump
and a programmed purge cycle that clears the pluming lines for 30
seconds every 12 hours from the time the spa is energized.

FOR ADDITIONAL FEATURES (see page 15)

PUMP 1

SPA LIGHT

HEAT MODES

(SEE PAGE 15)

TEMP UP

TEMP DOWN

PUMP 2