S-3, G-2.5 and G-3 Display Messages
ACTION REQUIRED
The control panel will be disabled until power returns. Spa settings
will be preserved until next power up.
After the pump has been running for 2 minutes, the temperature will
be displayed.
DO NOT ENTER THE WATER. Remove the spa cover and allow water
to cool. Once the heater has cooled, reset by pushing any button. If
spa does not reset, shut off the power to the spa and call your dealer
or service organization.
DO NOT ENTER THE WATER. Remove the spa cover and allow water
to cool. At 107
°
F, the spa should automatically reset. If spa does not
reset, shut off the power to the spa and call your dealer or service
organization.
No action required. The pump and blower automatically will activate
regardless of spa status.
If the problem persists, contact your dealer or service organization.
(May appear temporarily in an overheat situation and disappear when
the heater cools.)
If the problem persists, contact your dealer or service organization.
(May appear temporarily in an overheat situation and disappear when
the heater cools.)
If the problem persists, contact your dealer or service organization.
Check water level in spa. Refill if necessary. If the water level is okay,
make sure the pumps have been primed. If problem persists, contact
your dealer or service organization.
Follow action required for "HL" message. Heating capability of the
spa will not reset automatically; you may press any button to reset.
Check water level in spa. Refill if necessary. If water level is okay,
make sure the pumps have been primed. Press any button to reset,
or this message automatically will reset within 15 minutes. If problem
persists, contact your dealer or service organization.
Follow action required for "dr" message. Spa will not automatically
reset. Press any button to reset.
MEANING
No message on display.
Power has been cut off to the spa.
Temperature unknown.
"Overheat" - The spa has shut down. One of the sensors
has detected 118
°
F at the heater.
"Overheat" - The spa has shut down. One of the sensors
has detected that the spa water is 110
°
F.
"Ice" - Potential freeze condition detected.
Spa is shut down. The sensor that is plugged into the
Sensor "A" jack is not working.
Spa is shut down. The sensor that is plugged into the
Sensor "B" jack is not working.
Sensors are out of balance. If alternating with spa
temperature, it may just be a temporary condition. If
flashing by itself, spa is shut down.
A significant difference between temperature sensors has
been detected. This could indicate a flow problem.
Persistent low flow problems. (Displays on the fifth
occurrence of "HL" message within 24 hours.) Heater is
shut down, but other spa functions continue to run
normally.
Possible inadequate water, poor flow, or air bubbles in
detected in the heater. Spa is shut down for 15 minutes.
Inadequate water detected in heater. (Displays on third
occurrence of "dr" message.) Spa is shut down.
MESSAGE
--
HH
OH
IC
SA
Sb
Sn
HL
LF
dr
dY
16
Summary of Contents for Genius G-2.5
Page 22: ...000798 10 04...
