Page 42
Step 66
Step 67
Attach
E6 Porch Legs
to K6 Rail with 5/16” X 2” Hex Bolts,
Lock Washers, Flat Washers and Spike T-Nuts.
(
Note: Holes in top of E6 Legs toward outside. Per
Diagram.)
Attach
P33 Bottom Wall Rail
to B1 and E6 with
5/16” X 1 ½” Lag Screw, Lock washer, and Flat
Washer.
E6
E6
K6
P33
Step 68
Step 69
Level and center
E6 Porch Leg
up and down and place Y30-
40G against E6 and mark Floor Board. Drill Floor Board with
3/8” drill bit and attach Y30-40G with ¾” Phillips truss head
bolt with 5/16” Flat Washer and 5/16” Lock Washer and Flat
Washer on barrel nut to Floor and finish by using 5/16” X 1 ½”
Lag Screw, Lock Washer and Flat Washer through Y30-40G
into E6.
Attach Four
P24 Wall Boards
to K19 and
P2 with 1 1/8” Wood Screws 2 5/8” apart.
P24
P24
K19
P2
P24 - Wall Board - 4 Holes - 23 Required
.625 x 3.375 x 28.625 [1.59 x 8.57 x 72.71]
P33 - Wall Rail - 2 Hole - 1 Required
.625 x 3.375 x 6.5 [1.59 x 8.57 x 16.51]
E6 - Porch Leg - 2 Hole - 2 Required
1.375 x 3.375 x 50.5 [3.49 x 8.57 x 128.27]
B1
FLAT
WASHER
LOCK
WASHER
FLAT
WASHER
BARREL
NUT
BOLT
5/16 X 2"
HEX
HEAD
BOLT
5/16 X 1 1/2"
LAG
SCREW
5/16"
INTERNAL
TOOTH
LOCK
WASHER
5/16" FLAT
WASHER
5/16"
SPIKE TEE
NUT
Y30-40G
2" x2" METAL
BRACKET
#8 X 1-1/8"
WOOD
SCREW
1/4"
BARREL
HEAD
NUT
1/4 X 3/4"
PHILLIPS
TRUSS
HEAD
BOLT
© Copyright Leisure Time Products Inc.
Sky Fort 09-0112
2" x2" METAL
BRACKET
Y30-40G
Note: Pilot drill with 3/16” bit.
24 1/8”
