Page 54
Step 100
Step 101
Measure down 8” from top of E1 Monkey Bar Ladder Rails and
mark center and pilot drill with 3/16” bit and attach
Y10-16.5G
Metal Grips
with 5/16” X 1 ½” Lag Screws, Lock Washers, and
Flat Washers. Use hole in bottom of Y10-16.5G Metal Grip to pilot
drill and finish securing Grip with Lags and Washers. In front of
set, measure up 4 ½” from Floor Boards on B1 Leg and E6 and
pilot drill 3/16” Hole and attach Y10-16.5G Metal Grip again use
hole in Y10-16.5G Metal Grip pilot drill and finish securing with
lags and washers.
Back Wall Opening – Entry Ladder, attach
Y10-16.5G Metal Grips to B7 Post measure up
4 ½” and pilot drill post with 3/16” drill bit and
attach with 1 ½” lag screws, lock washers and
flat washers. You will need to mark and drill
through K13 Wall Rail with 3/8” drill bit to fasten
Y10-16.5G Metal Grip with ¾” Phillips Truss
Head bolt, Lock Washer, Flat Washer, and
Barrel Nut.
5/16 X 1 1/2"
LAG
SCREW
5/16"
INTERNAL
TOOTH
LOCK
WASHER
5/16" FLAT
WASHER
1/4 X 3/4"
PHILLIPS
TRUSS
HEAD
BOLT
1/4"
BARREL
HEAD
NUT
© Copyright Leisure Time Products Inc.
Sky Fort 09-0112
Y10-16.5G
Metal Grip
Y10-16.5G
Y10-16.5G