Page 59 - MAINTENANCE
Question:
Why is my play product leaning (racking)?
Answer: Leaning occurs in play products installed on uneven ground. Realignment will be
necessary and is covered in the "required periodic maintenance" section of this manual
Question:
What can I do about squeaking swing connector hangers?
Answer: To eliminate the squeak, spray the nylon bushings with WD-40 or other household
lubricant. Some families like the squeaking as it allows them to hear where the children are
playing.
Question:
Why is the wood splintering under the bolts when I tighten the hardware?
Answer: Wood will splinter when compressed. The compression caused by over-tightening
fractures wood fibers and is an indication that you are cranking down too hard on the hardware. If
splintering has occurred, we recommend that you purchase larger diameter flat washers to install
under the head of the bolts.
Question:
Why does my play product have mold growing on it? What can I do to remove it and
keep it clean of mold and mildew?
Answer: Because the structure is wooden rather than concrete or steel, in areas of high humidity
mold and/or mildew may occur. A solution of 1 part bleach, 2 parts water applied with a sponge
should clean the problem areas. Once the solution is dry, a water sealant should be applied to the
entire swingset.
Question:
What if my ground stakes won't go in the ground
?
Answer: If your ground is too hard, you can dig and cement the metal anchors in the ground.
Question:
What if my ground stakes won't stay in the ground?
Answer: This is probably caused by your ground being too soft. The ground stakes can be
concreted or cemented into the ground. Do not concrete or cement the playset itself, only the
ground stakes.
Question:
Who can I hire to assemble my playset?
Answer: We do not suggest assemblers. Please refer to your yellow pages or ask for a
recommendation from where you purchased your playset.
© Copyright Leisure Time Products Inc.
Sky Fort 09-0112
