30
．
[MENU+3+0]PTT ID
（
PTT ID
）
PTT ID allows you to send a code that identifies your
specific transceiver. The PTT ID code is defined in the
programming software; the default ID is “123”.
You can also set whether PTT ID’s are spoken or
displayed. If voice is selected, ID’s of up to five digits
will be spoken. However, up to 14 digit ID’s can be
displayed if voice ID’s are disabled.
Each channel stores whether the PTT ID is enabled.
The PTT ID can be sent:
1.
At the beginning of the transmission: The ID is sent
immediately when the PTT key is pressed.
2.
At the end of the transmission: the PTT ID is sent
when the PTT key is released.
3.
Both: the PTT ID is sent both when the PTT key is
pressed and again when it is released.
31
．
[MENU+3+1]Reverse
（
Rev
）
The Reverse feature can only be enabled if Offset
Frequency and RPT Type, are also set. The Reverse
function swaps the receive and transmit frequencies so
that you can hear another transceiver’s calls directly
rather than through a repeater. This would be useful in
order to determine whether you can establish direct
contact with a nearby station, freeing up the repeater
for other uses.
To set the Reverse function, set Menu 31 to “ON”. To
return to normal operation, set Menu 31 to “OFF”.
Summary of Contents for UV-52
Page 1: ......
Page 11: ...Getting Acquainted ...
