Note: Offset frequency setting is only available in
VFO mode. It cannot be set in already programmed
memory channels. When using the programming
software, you must specify both receive and transmit
frequencies directly.
A new offset value only can effect after the offset
direction be chosen again.
35
．
[MENU+3+5]PTT Set
（
Set PTT
）
The PTT B can be set the same as PTT A, or not the
same with PTT A through Menu 35. When PTT A=B,
push PTT A or B, the radio transmit the signal for
current channel; when PTT A!=B, push PTT A to
transmit signal for channel A, push PTT B to transmit
for Channel B. The default is :A!=B.
36
．
[MENU+3+6]Save level
（
Savlev
）
There are four battery save levels:1/2/3/4.
37
．
[MENU+3+7] Scan Mode
（
SCNMod
）
Scan mode allows you to monitor several channels
more efficiently. Channels are scanned until activity is
detected on a channel. Depending on the scan mode,
scanning may continue after a specific length of time,
or it will only continue when the channel is inactive.
Scan Mode:
Select the scan mode in Menu37. There
are two modes:
Time operated (TO): Scanning stops when an
active channel is encountered. The scan will pause
Summary of Contents for UV-52
Page 1: ......
Page 11: ...Getting Acquainted ...
