Do not let others use your S1 unless the person has read the manual carefully;
Please do a good job of safety during driving, no matter when you ride,
please wear approved, in line with the first type, contains a cap and can protect
the back of the head helmets, while wearing such as gloves, eye protection
equipment, elbow pads and other protective equipment;
Do not ride when not on condition or unable to comply with the instructions and
warnings of the manual;
Do not ride on the influence of alcohol or medicine;
Please get off in time in the cases of less power, continuous alarm and speed
reduced, and charge timely to ensure safety;
Please check before riding, do not ride before troubleshooting of any loose
or damaged.
Keep the air pressure of the tires under 35 PSI;
Use the original factory allowed replacements, and ask local distributor or professional technicians to install;
Replace the tires when the tires are damaged or worn seriously.
If surface of S1 stains , use soft cloth dipped with some water and wipe it . If the stain is hard to
clean, smear toothpaste on and use toothbrush to scrub repeatedly, then clean it again with
wet cloth;
Notice :Do not use alcohol, petrol, kerosene or other corrosive, volatile chemical solvents to
clean the bike, or it will damage the appearance and internal structure. Do not use a water gun
with pressure to rinse. While cleaning, make sure S1 e-bike is powered off, cable is unplugged
and charging port is covered, in case of electric shock or serious failure.
Please store the S1 e-bike in dry and cool indoor places when not used, and do not leave it out
of doors for long time;
S1 Daily Maintaining
Maintaining for battery of S1 e-bike
The failure can not be restore. The battery has a intelligent board inside can record the charge and
discharge status. It can not be recharged if damaged by long time no-charged, which can not get
free warranty service. (Notice: Prohibit non-professional personnel to disassemble the battery pack.
Otherwise it may cause serious security incident when happening electric shock or short circuit!)
Daily lubricating maintaining (see below table)
Daily cleaning
Lubricating position
Lubricating period
Recommended oil for Lubricating
Front fork set
1 year
1 year
1 year
1 year
Lubricating grease
Lubricating grease
Lubricating grease
Lubricating grease
Front/rear axle
Bottom Bracket
Pedal axle
Chain wheel
Chain
Freewheel interior
Brake lever
1 week
1 week
1 month
1 month
Lubricating oil
Lubricating oil
Lubricating oil
Lubricating oil
To avoid the brake system failure , please do not add the oil to the brake pads.
Advised temperature for storing the battery : -20
℃
-50
℃
, otherwise the battery may fail or overheating,
even causing fire;
Suitable place for safe cycling and operation
Function well of brake system
Right position for the safety identification and easily understood mark
S1
series
Beyond fashion, better know you!
13
14
Before using, make sure that all locking parts are locked in place;
(Follow the instructions to install, to avoid causing injury.)
Check the fixing of all screws before use to avoid self-locking nuts or other fixed parts loose;
Inflate the tire appropriately, and make sure there is enough anti-skid;
Check the axle protective cover and other protective equipment are accurate or not;
Electric bike chain might loose after riding a period of time, and adjust methods as follows:
Loosen the nuts on both sides of the rear axle and tighten the chain nut until the chain is tight,
and pay attention to the rear wheel horizontal paralleled with the frame , and then tighten nuts on
both sides. If the chain is tight, repeat the operation as above( Chain sagging 10mm-15mm).
Adjust the saddle height, should not expose the safety line , and pay attention to the saddle nut and
saddle tube clamping. Tightening torque for handle should not less than 18Nm;
Before riding, please follow preparations and inspections required by manufacturer:
Wearing helmet, kneecap, gloves, elbow and other protective equipment
Active safety protection measures
